Message Types are utilized by CU*BASE to determine what action is to be taken for this transaction. The original message type is the incoming message received by CU*BASE from your vendor. Depending on the Message Type received by CU*BASE, the system could perform any of the following type of transactions (this is not an all inclusive listing): Balance Inquiry Request for Authorization of Transaction Advice of Authorization (Vendor/VISA/MC approved) Transfer of Funds Request Reversal of Transac  More...

The settings that control how this works are part of Tool #558 NSF/Overdraft Transfer Configuration , on the Overdraft Protection Activation screen. There are two flags for ANR/courtesy pay: Use Negative Balance Limits for Authorizations and Use Negative Balance Limits for Posting . They control whether the member's ANR limit is added when determining the available balance amount. There are four different combinations of these flags: Authorization Flag Posting Flag Description of Result  More...

Our system does allow for temporary or permanent changes in limits, depending on your configuration. Limit validation can be described as follows: When a transaction is received, the program looks to the current limits to approve the transaction. CBX compares the date of the last transaction to the system date. If the system date and the new transaction date differ from the last transaction, daily remaining limits are then reset. This implies that the transaction may occur on a non-business day  More...

Launch Tool #145 ATM/Dbt/Crdt: Audit Card Status Changes , locate the activity record (the User/Employee ID column will say ONLINE STS ), select it and choose Additional Status Information. The following vendor response codes may be sent from STAR/PSCU: ■ 00 - Successful ■ 25 - Record Not on File (P) Card not in CMA ■ 26 - Record Already on File (AM) Card already activated ■ 29 - Unsuccessful (any other denial code) SGD Activation not supported, any other problems with processing the trans  More...

If the credit union’s back office has determined that it’s ATM, debit, or credit card G/ls are ‘OUT OF BALANCE,’ they can use the reports below to assist in locating transactions which should have posted but did not post to the general ledger. The recon program documents the differences on two recon reports. The Online Reconciliation Recon to Online Match (PRCNXX1) documents the entries made in the vendor file and any entries that appear in the vendor file that are not  More...

No. ATM transactions are not included in the debit card round-up toolkit. It is either signature-based debit card transactions or POS (pin-based) transactions.

The consequences of accidentally NOT ordering a card, while inconvenient, are slightly less than the consequences of ordering a card unintentionally. That’s especially true in cases where ordering a card automatically shuts down an existing card, like when there is a second person with that card that suddenly can’t use theirs. (Depends on the vendor setup.) There are situations where CUs use the card reorder feature to change PINs only, or update expiration dates, or something else a  More...

First, use Tool #146 ATM/Dbt/Crdt: BIN Config Inquiry to review what your current limits are. Then, if you would like to change those limits, contact the Cards Payments team ( cardsandpayments@cuanswers.com ) and we’ll be happy to assist with that change.

Yes, you can designate your credit union's own savings (or checking) account number to receive round-up funds when setting up a member's round-up transfers, if you wish. 1. Launch Tool #14 Member Personal Banker for a member who wants to participate 2. Select the Debit Card Roundup enrollment button and double click on the member's desired suffix 3. Enter in your credit union's internal account for the account to which you'd like the round-up funds transferred (this accou  More...

No. This law actually pertains to merchant card programs where the merchant is collecting payments for services and goods sold. Since we do not run merchant programs on our platform, this reporting requirement does not apply to us.

Yes. You can pull a credit report for any service using the online credit bureau process. Using Tool #53 Process Member Applications, use action code CR to pull the report without creating a loan request and application. We can then create Member Services denial notices for debit cards, checking accounts, ATM cards, etc.

The process can vary a bit according to the vendor, but here's a discussion about how it works for credit unions on the CO-OP network, as an example. In most cases, debit card authorizations create a Misc. Secured Shares record on the member's account to hold the funds. When the actual transaction comes in, this record is automatically deleted. (There are exceptions to this rule, such as gas purchases.) A little history: In the past, debit card authorizations would add a hold to an ind  More...

Credit Union ABC has activated the Reg E opt in/opt out feature and has configured a NSF fee. John Smith, a member of ABC Credit Union, has elected to opt out of receiving overdraft services. John will not be charged an NSF fee on one-time PIN ATM Debit (13) and Debit Signature (16) transactions. John will be charged an NSF fee on any recurring PIN ATM Debit (13) and Debit Signature (16) transactions, which are not covered by the member's Reg E opt in/opt out setting.

In many cases, the reason an opted-out member receives the non-return fee is because this transaction is a recurring payment. Recurring transactions are not covered by the Reg. E Opt In/Out requirements. You can identify this by the * after the DBT/WDR in the eighth position of the transaction description on the member's transaction history. Recurring transactions are posted, and the member is charged the fee, even if the member is Opted Out.

Unfortunately, no. Access to those commands in your custom training environment will be blocked for your protection.

The core system will not block a transaction when a member is traveling. That is done on the vendor's side. You will want to put in a travel notification for this member's debit card or credit card directly with your card vendor.

The MSG TYPE values describe types of 'authorizations' and 'transactions' processed through the CO-OP network. Authorizations: (100 110 120 130) For PIN Authorizations there is no hold on the member's funds. However, Signature Authorizations place a hold, CU*BASE shows this as a debit authorization comment in OTB processing. In either case this transaction is not posted to the members account. This is just a POS (point of sale) authorization for the merchant. It could be e  More...

The fields are related to Process Codes, in that they are derived from the code attached to the message received from the plastics processor (vendor, or switch). The Type you see in the initial Type column of the Activity screen relates directly to the Transaction Description when you view additional transaction details. Transaction types may not apply to all vendors. Examples of these labels are as follows: DEP (Deposit Transactions) ATM/DEP A deposit made at an ATM. ATM/DEP - including a $  More...

In some cases, the general upload file that is received by CU*Answers on a daily basis only contains accounts where a member has had a change to their account. Contact your OTB vendor to see if you can request a full file to be sent so that all card information would be sent in the upload file to CU*Answers. (In some cases if your CU is already being charged for the upload it is possible there would be no change in price to have the full file sent over.)

The reports associated with the Standard ATM/Debit process are as follows: LPANTX1 Detail Information for transactions (Card # order) LPANTX2 Summary Information for transactions (BIN order) - USED FOR BALANCING SETTLEMENT TOTALS LPANEX Exceptions report (Broken down into three sections: Denials, Unposted Items, and ISA Fees) LPANAC1 Detail Information for transactions (Account # order) LPANAC2 Summary Information for transactions (BIN order) PADLIM Report  More...

T o order an online credit card for a co-applicant on the loan account, you would complete the following steps: Launch Tool #12 Update/Order Online Credit Cards Enter the member number and suffix for the Visa loan account OR If you have the last 4 digits of the primary member's Visa card number, you may enter that instead Use Enter to continue On the next screen you will see a card that has been ordered for your primary member only. On the lower left corner of the screen, choose Add   More...

It's possible but fairly rare, given how most CUs set up their statement criteria. The two statement types are independent as far as the criteria that determine whether a member gets a statement or not. Typically a CU sets up their regular account statement to look at OC (open credit) accounts, which includes online credit cards, and produce a regular statement if there is any activity. Likewise, a credit card statement is generally set up to produce a CC statement only if there is activi  More...

Credit card finance charges can be confusing as they are different from a normal simple daily interest consumer loan, because billing cycles play a part in the finance charge calculation. Both current and previous billing cycles are required for the calculation to qualify for a configured grace period. Grace period flags are determined by the credit union and disclosed in their credit card disclosures. Finance charges are waived if the account qualifies for the grace period configured in the loa  More...

Printed Statement Style fees are triggered only by production of a regular account statement (based on a file called STPRINT01, which is generated only with regular statements, not CC statements) . If a member gets only a credit card statement, they wouldn’t get a fee that particular month. If the next month they get both a credit card statement and a regular statement, then they would get a fee that time. (Note: We do always produce a year-end statement for every member, no matter wha  More...

Yes. When reviewing the history on the account, you can select the additional transaction information for the transaction in question. This will take you to the Recorded Card Activity screen for this transaction. The top of the screen presents the last four digits of the card #, and right below that, the embossed names. If a husband and wife each have a card with the same PAN (card #), you can find the card sequence # in the top right corner of the Recorded Activity Screen. This will allow y  More...